Choose a fitting
Tap a shape to see it. Measuring and prices need a trade account.
Pick your shape (24)
Pipework (9)Round pipe — straights, bends, reducers, tees, end caps
Straight pipe
Casing along a straight run — 1 m or half-metre lengths
Radius bend — segmented
A bend built up from segments, any radius you like
Elbow — mitred
A hard corner in two pieces, no throat. Curved turn? That's the radius bend
Reducer — in line
Where the pipe steps down to a smaller size on the same centre
Reducer — flat side
Steps down but keeps one side of the run level
Tee — branch off
Where a branch comes off the main run
Oblique tee — angled branch
A branch coming off at an angle instead of square
End cap
Closes off the end of a lagged pipe. Two pieces, so it goes on after
Set / offset
Steps the run sideways to get around something
Ductwork (8)Square and rectangular duct — straights, bends, reducers, transitions
Straight duct
Four panels — bottom tray, two sides, top tray
Curved-back bend
A duct bend with a smooth round back
Square duct bend
A sharp mitred elbow, with turning vanes if you want them
Duct reducer
Where the duct gets smaller
Duct tee — branch off
Where a branch comes off the main duct
Transition
Change of size or shape — one duct onto another
Square to round
Rectangular duct onto round pipe
Z-bar trim
A folded strip with three legs — carries and closes a run
Boxes (3)Lift-off covers for valves and flange joints
Vessel ends (4)Tanks and vessels — shells, cones, flat ends, domed ends
