Set / offset
A set steps the run sideways around an obstruction in three mitred pieces.
Three-piece mitred sets for stepping a clad pipe run around an obstruction. Enter the offset and the angle; the cutting pattern comes out the far side.
Workshop detailsHow the workshop makes it. You don’t need this to order.
How it's made: Parallel line, three mitred pieces.
What a set is and how it takes a pipe around something
A sideways step in the run
A set, also called an offset, steps a pipe run sideways around an obstruction, then carries on in the same direction as before. We make it in three mitred pieces: an angled middle piece between two straight ends.
What to measure
The size over the lagging and the offset, which is how far the run moves sideways, centre to centre. Then the angle, which starts at 45°, and the length of each straight end. A quick sketch with those numbers on it is enough to send. If the run steps sideways and up at the same time, put both on the sketch and the office will look at it.
Small pipes
Under 12 cm of finished cladding, a set is made as two 45° mitred elbows. Under 8.5 cm it is too small to make even that way, so send it to the office and we price it the same day.
Metal and finish
Aluminium, 0.6 to 0.8 mm, plain or stucco embossed. Stainless steel 304 / 316 is made to order.
Before you order
Is there a minimum order?
No. One fitting is fine. Any delivery charge on a small order is shown on your quote before you order.
Do fixings come with the cladding?
No. Our prices are for the cladding only. Bands, rivets and screws are not included, but we can supply them with your order: ask, and they go on your quote.
What if you get a fitting wrong?
If we got it wrong, we remake it the same week, no charge. We make to the measurements you send, so check them before you send.
Log in to measure this one
The measuring tool — the sizes, the drawing and the cutting file — needs a free CladFab account. It takes a minute to open: confirm the email we send you, then use it on your phone on site the same day.
Rather just send us the job? +353 87 212 6144 or send a job to quote — we come back the same day.
No account needed. Send it whichever way suits you:
Email goes to sales@cladfab-ltd.com. Put your name, mobile and the sizes in, and attach the photo or drawing.